Chapter 9 Wireless
UAG Series User’s Guide
138
Each field is described in the following table.
Table 54 Configuration > Wireless > AP Management
LABEL DESCRIPTION
Edit Select an AP and click this button to edit its properties.
Remove Select one or multiple APs and click this button to remove the AP(s) from the list.
Note: If in the Configuration > Wireless > Controller screen you set the Registration
Type to Always Accept, then as soon as you remove an AP from this list it
reconnects.
Reboot Select one or multiple APs and click this button to force the AP(s) to restart.
LED On Select an AP and click this button to disable the AP’s LED suppression mode. The AP
LEDs stay lit after the AP is ready. This button is not available if the selected AP doesn’t
support suppression mode.
LED Off Select an AP and click this button to enable the AP’s LED suppression mode. All the
LEDs of the AP will turn off after the AP is ready. This button is not available if the
selected AP doesn’t support suppression mode.
# This field is a sequential value, and it is not associated with any entry.
IP Address This field displays the IP address of the AP.
MAC Address This field displays the MAC address of the AP.
Model This field displays the AP’s hardware model information. It displays N/A (not
applicable) only when the AP disconnects from the UAG and the information is
unavailable as a result.
R1 Mode / Profile This field displays the operating mode (AP) and AP profile name for Radio 1. It displays
n/a for the profile for a radio not using an AP profile.
R2 Mode / Profile This field displays the operating mode (AP) and AP profile name for Radio 2. It displays
n/a for the profile for a radio not using an AP profile.
Mgnt. VLAN ID(AC) This displays the Access Controller (the UAG) management VLAN ID setting for the AP.
Mgnt. VLAN ID(AP) This displays the runtime management VLAN ID setting on the AP. VLAN Conflict
displays if the AP’s management VLAN ID does not match the Mgnt. VLAN ID(AC).
This field displays n/a if the UAG cannot get VLAN information from the AP.
Description This field displays the AP’s description, which you can configure by selecting the AP’s
entry and clicking the Edit button.
To Next Page
Loading...
