Chapter 2 Hardware Installation and Connection
UAG Series User’s Guide
41
Figure 19 Rear Panel: UAG2100 or UAG4100
Console Port
Connect this port to your computer (using an RS-232 cable) if you want to configure the UAG using
the command line interface (CLI) via the console port.
For local management, you can use a computer with terminal emulation software configured to the
following parameters:
• VT100 terminal emulation
• 115200 bps
• No parity, 8 data bits, 1 stop bit
• No flow control
Connect the male 9-pin end of the RS-232 console cable to the console port of the UAG. Connect
the female end to a serial port (COM1, COM2 or other COM port) of your computer.
2.4.2 UAG5100
The following figure shows the rear panel of the UAG. The rear panel contains a connector for the
power receptacle.
Figure 20 Rear Panel: UAG5100
Radio 2 (5 GHz)
Radio 1 (2.4 GHz)
To Next Page
Loading...
