ZyXEL Communications UAG5100 - 9.2 Controller Screen; 9.3 AP Management Screen

Chapter 9 Wireless
UAG Series User’s Guide
137
9.2 Controller Screen
Use this screen to set how the UAG allows new APs to connect to the network. Click Configuration
> Wireless > Controller to access this screen.
Figure 94 Configuration > Wireless > Controller
Each field is described in the following table.
9.3 AP Management Screen
Use this screen to manage all of the APs connected to the UAG. Click Configuration > Wireless >
AP Management to access this screen.
Figure 95 Configuration > Wireless > AP Management
Table 53 Configuration > Wireless > Controller
LABEL DESCRIPTION
Registration
Type
Select Manual to add each AP to the UAG for management, or Always Accept to
automatically add APs to the UAG for management.
Note: Select the Manual option for managing a specific set of APs. This is recommended as the
registration mechanism cannot automatically differentiate between friendly and rogue
APs. For details on how to handle rogue APs, see Section 7.16 on page 116.
APs must be connected to the UAG by a wired connection or network.
Apply Click Apply to save your changes back to the UAG.
Reset Click Reset to return the screen to its last-saved settings.