Chapter 23 Web Authentication
UAG Series User’s Guide
260
•Use the Configuration > Web Authentication > Advertisement screens (Section 23.4 on
page 283) to enable and set advertisement links.
23.1.2 What You Need to Know
Forced User Authentication
Instead of making users for which user-aware policies have been configured go to the UAG Login
screen manually, you can configure the UAG to display the Login screen automatically whenever it
routes HTTP traffic for anyone who has not logged in yet.
Note: This works with HTTP traffic only. The UAG does not display the Login screen when
users attempt to send other kinds of traffic.
The UAG does not automatically route the request that prompted the login, however, so users have
to make this request again.
Finding Out More
See Section 23.2.2 on page 264 for an example of using an authentication policy for user-aware
access control.
23.2 Web Authentication
Click Configuration > Web Authentication to display the screen.
23.2.1 General Screen
The Web Authentication General screen displays the general web portal settings and web
authentication policies you have configured on the UAG. Use this screen to enable web
authentication on the UAG.
To Next Page
Loading...
