Chapter 9 Wireless
UAG Series User’s Guide
141
Figure 97 Configuration > Wireless > AP Management > Edit AP List > Edit Port
Each field is described in the following table.
9.3.3 VLAN Add/Edit
Use this screen to create a new VLAN or configure an existing VLAN on the UAG.
To access this screen, click Add or select a VLAN and click the Edit button in the VLAN Member
Configuration table of the Configuration > Wireless > AP Management > Edit AP List
screen.
Table 56 Configuration > Wireless > AP Management > Edit AP List > Edit Port
LABEL DESCRIPTION
Enable Select this option to activate the port. Otherwise, deselect it.
Name This shows the name of the port.
Native VID (PVID) A PVID (Port VLAN ID) is a tag that adds to incoming untagged frames received on a
port so that the frames are forwarded to the VLAN group that the tag defines.
Enter the PVID from 1 to 4094 for this port.
OK Click OK to save your changes back to the UAG.
Cancel Click Cancel to close the window with changes unsaved.
To Next Page
Loading...
