ZyXEL Communications UAG5100 - CHAPTER 52 Shutdown; 52.1 Overview; 52.1.1 What You Need To Know; 52.2 The Shutdown Screen

UAG Series User’s Guide
582
CHAPTER 52
Shutdown
52.1 Overview
Use this to shutdown the device in preparation for disconnecting the power. See also Section 1.5 on
page 35 for information on different ways to start and stop the UAG.
Always use the Maintenance > Shutdown > Shutdown screen or the
“shutdown” command before you turn off the UAG or remove the power.
Not doing so can cause the firmware to become corrupt.
52.1.1 What You Need To Know
Shutdown writes all cached data to the local storage and stops the system processes.
52.2 The Shutdown Screen
To access this screen, click Maintenance > Shutdown.
Figure 417 Maintenance > Shutdown
Click the Shutdown button to shut down the UAG. Wait for the device to shut down before you
manually turn off or remove the power. It does not turn off the power.
You can also use the CLI command shutdown to shutdown the UAG.