Chapter 39 Addresses
UAG Series User’s Guide
445
Figure 300 Configuration > Object > Address > Address Group
The following table describes the labels in this screen. See Section 39.3.1 on page 445 for more
information as well.
39.3.1 Address Group Add/Edit Screen
The Address Group Add/Edit screen allows you to create a new address group or edit an existing
one. To access this screen, go to the Address Group screen (see Section 39.3 on page 444), and
click either the Add icon or an Edit icon in the Configuration section.
Table 206 Configuration > Object > Address > Address Group
LABEL DESCRIPTION
Configuration
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The UAG confirms you want to remove it
before doing so.
Object Reference Select an entry and click Object Reference to open a screen that shows which settings
use the entry. See Section 10.3.2 on page 165 for an example.
# This field is a sequential value, and it is not associated with a specific address group.
Name This field displays the name of each address group.
Description This field displays the description of each address group, if any.
Reference This displays the number of times an object reference is used in a profile.
To Next Page
Loading...
