ZyXEL Communications UAG5100 - CHAPTER 7 Monitor; 7.1 Overview; 7.1.1 What You Can Do in this Chapter

UAG Series User’s Guide
91
CHAPTER 7
Monitor
7.1 Overview
Use the Monitor screens to check status and statistics information.
7.1.1 What You Can Do in this Chapter
Use the Monitor screens for the following.
•Use the System Status > Port Statistics screen (see Section 7.2 on page 92) to look at packet
statistics for each physical port.
•Use the System Status > Port Statistics > Graph View screen (see Section 7.2 on page 92)
to look at a line graph of packet statistics for each physical port.
•Use the System Status > Interface Status screen (see Section 7.3 on page 94) to see all of
the UAG’s interfaces and their packet statistics.
•Use the System Status > Traffic Statistics screen (see Section 7.4 on page 97) to start or
stop data collection and view statistics.
•Use the System Status > Session Monitor screen (see Section 7.5 on page 99) to view
sessions by user or service.
•Use the System Status > DDNS Status screen (see Section 7.6 on page 101) to view the
status of the UAG’s DDNS domain names.
•Use the System Status > IP/MAC Binding screen (see Section 7.7 on page 101) to view a list
of devices that have received an IP address from UAG interfaces with IP/MAC binding enabled.
•Use the System Status > Login Users screen (see Section 7.8 on page 102) to look at a list of
the users currently logged into the UAG.
•Use the System Status > Dynamic Guest screen (see Section 7.9 on page 103) to look at a list
of the guest user accounts, which are created automatically and allowed to access the UAG’s
services for a certain period of time.
•Use the System Status > UPnP Port Status screen (see Section 7.10 on page 105) to look at
a list of the NAT port mapping rules that UPnP creates on the UAG.
•Use the System Status > USB Storage screen (see Section 7.11 on page 106) to view
information about a connected USB storage device.
•Use the System Status > Ethernet Neighbor screen (see Section 7.12 on page 107) to view
and manage the UAG’s neighboring devices via Layer Link Discovery Protocol (LLDP).
•Use the AP Information > AP List screen (see Section 7.13 on page 109) to view which APs
are currently connected to the UAG.
•Use the AP Information > Radio List screen (see Section 7.14 on page 112) to view statistics
about the wireless radio transmitters in each of the APs connected to the UAG.
•Use the Station Info > Station List screen (see Section 7.15 on page 115) to view statistics
pertaining to the connected stations (or “wireless clients”).