ZyXEL Communications UAG5100 - 25.3.1 Add;Edit a Session Limit Rule

Chapter 25 Security Policy
UAG Series User’s Guide
298
25.3.1 Add/Edit a Session Limit Rule
In the Configuration > Security Policy > Session Control screen, click the Add icon or select
an entry and click the Edit icon to display the Add/Edit Session Limit screen. Use this screen to
configure rules that define a session limit for specific users or addresses.
Figure 210 Configuration > Security Policy > Session Control > Add/Edit
The following table describes the labels in this screen.
Move To change a rule’s position in the numbered list, select the rule and click Move to display a
field to type a number for where you want to put that rule and press [ENTER] to move the
rule to the number that you typed.
The ordering of your rules is important as they are applied in order of their numbering.
Status This icon is lit when the entry is active and dimmed when the entry is inactive.
# This is the index number of a session limit rule. It is not associated with a specific rule.
User This is the user name or user group name to which this session limit rule applies.
IPv4 Address This is the IPv4 address object to which this session limit rule applies.
Description This is the information configured to help you identify the rule.
Limit This is how many concurrent sessions this user or address is allowed to have.
Apply Click Apply to save your changes back to the UAG.
Reset Click Reset to return the screen to its last-saved settings.
Table 132 Configuration > Security Policy > Session Control (continued)
LABEL DESCRIPTION
Table 133 Configuration > Security Policy > Session Control > Add/Edit
LABEL DESCRIPTION
Create new
Object
Use to configure any new settings objects that you need to use in this screen.
Enable Rule Select this check box to turn on this session limit rule.
Description Enter information to help you identify this rule. Use up to 60 printable ASCII characters.
Spaces are allowed.