Chapter 10 Interfaces
UAG Series User’s Guide
159
10.3.1 Ethernet Edit
The Ethernet Edit screen lets you configure IP address assignment, interface parameters, DHCP
settings, connectivity check, and MAC address settings. To access this screen, select an entry in the
Ethernet summary screen and click the Edit icon. (See Section 10.3 on page 157.)
Note: If you create IP address objects based on an interface’s IP address, subnet, or
gateway, the UAG automatically updates every rule or setting that uses the object
whenever the interface’s IP address settings change. For example, if you change
the LAN’s IP address, the UAG automatically updates the corresponding interface-
based, LAN subnet address object.
IP Address This field displays the current IP address of the interface. If the IP address is 0.0.0.0 (in
the IPv4 network), the interface does not have an IP address yet.
In the IPv4 network, this screen also shows whether the IP address is a static IP
address (STATIC) or dynamically assigned (DHCP). IP addresses are always static in
virtual interfaces.
Mask This field displays the interface’s subnet mask in dot decimal notation.
Apply Click Apply to save your changes back to the UAG.
Reset Click Reset to return the screen to its last-saved settings.
Table 66 Configuration > Network > Interface > Ethernet (continued)
LABEL DESCRIPTION
To Next Page
Loading...
