Chapter 17 SMTP Redirect
UAG Series User’s Guide
237
Figure 154 Configuration > Network > SMTP Redirect
The following table describes the labels in this screen.
17.2.1 The SMTP Redirect Edit Screen
Click Network > SMTP Redirect to open the SMTP Redirect screen. Then click the Add or Edit
icon to open the SMTP Redirect Edit screen where you can configure the rule.
Table 103 Configuration > Network > SMTP Redirect
LABEL DESCRIPTION
Enable SMTP
Redirect
Select this option to turn on the SMTP redirect feature on the UAG.
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings.
Remove To remove an entry, select it and click Remove. The UAG confirms you want to remove it
before doing so.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
Move To change a rule’s position in the numbered list, select the rule and click Move to display
a field to type a number for where you want to put that rule and press [ENTER] to move
the rule to the number that you typed.
The ordering of your rules is important as they are applied in order of their numbering.
# This field is a sequential value, and it is not associated with a specific entry.
Status This icon is lit when the entry is active and dimmed when the entry is inactive.
User/Group This is the user account or user group name to whose SMTP traffic this rule is applied.
Interface This is the name of the interface on which the SMTP traffic must be received.
Source Address This is the name of the source IP address object from which the SMTP traffic should be
sent. If any displays, the rule is effective for every source.
SMTP Server This is the IP address or Fully-Qualified Domain Name (FQDN) of the SMTP server to which
the matched SMTP traffic is forwarded.
Apply Click Apply to save your changes back to the UAG.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
