Chapter 17 SMTP Redirect
UAG Series User’s Guide
238
Figure 155 Network > SMTP Redirect > Edit
The following table describes the labels in this screen.
Table 104 Network > SMTP Redirect > Edit
LABEL DESCRIPTION
Enable Use this option to turn the SMTP redirect rule on or off.
User Use the drop-down list box to select the individual user or user group for which you want
to use this rule.
Select any to have the SMTP redirect rule apply to all of the SMTP messages that the
UAG receives from any user.
Interface Select the interface on which the SMTP traffic must be received for the UAG to forward it
to the specified SMTP server.
Source Address Select the source address or address group for whom this rule applies. Use Create new
Object if you need to configure a new one. Select any if the rule is effective for every
source.
SMTP Server Enter the IP address or Fully-Qualified Domain Name (FQDN) of the SMTP server.
OK Click OK to save your changes back to the UAG.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
