ZyXEL Communications UAG5100 - 9.3.4 AP Policy

Chapter 9 Wireless
UAG Series User’s Guide
143
9.3.4 AP Policy
Use this screen to configure the AP controller’s IP address on the managed APs and determine the
action the managed APs take if the current AP controller fails. Click Configuration > Wireless >
AP Management > AP Policy to access this screen.
Figure 99 Configuration > Wireless > AP Management > AP Policy
Each field is described in the following table.
Table 58 Configuration > Wireless > AP Management > AP Policy
LABEL DESCRIPTION
Force Override AC
IP Config on AP
Select this to have the UAG change the AP controller’s IP address on the managed
AP(s) to match the configuration in this screen.
Override Type Select Auto to have the managed AP(s) automatically send broadcast packets to find
any other available AP controllers.
Select Manual to replace the AP controller’s IP address configured on the managed
AP(s) with the one(s) you specified below.
Primary Controller Specify the IP address of the primary AP controller if you set Override Type to
Manual.
Secondary
Controller
Specify the IP address of the secondary AP controller if you set Override Type to
Manual.
Fall back to Primary
Controller when
possible
Select this option to have the managed AP(s) change back to associate with the
primary AP controller as soon as the primary AP controller is available.
Fall Back Check
Interval
Set how often the managed AP(s) check whether the primary AP controller is available.
Apply Click Apply to save your changes back to the UAG.
Reset Click Reset to return the screen to its last-saved settings.