Chapter 35 User/Group
UAG Series User’s Guide
412
The following table describes the labels in this screen.
35.5.1 Add/Edit MAC Address
Use this screen to configure the wireless client’s MAC address and save it into the UAG’s local user
database for MAC authentication.
Figure 278 Configuration > Object > User/Group > MAC Address > Add
The following table describes the labels in this screen.
Table 185 Configuration > Object > User/Group > MAC Address
LABEL DESCRIPTION
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings.
Remove To remove an entry, select it and click Remove. The UAG confirms you want to remove it
before doing so.
# This field is a sequential value, and it is not associated with a specific entry.
MAC Address/
OUI
The wireless client MAC address or OUI (Organizationally Unique Identifier). The OUI is the
first three octets in a MAC address and uniquely identifies the manufacturer of a network
device.
Description This field displays the description for each entry.
Table 186 Configuration > Object > User/Group > MAC Address > Add/Edit
LABEL DESCRIPTION
MAC Address/
OUI
Specify the wireless client’s MAC address or OUI (Organizationally Unique Identifier). The
OUI is the first three octets in a MAC address and uniquely identifies the manufacturer of a
network device.
This field is read-only if you are editing an existing entery.
Description Enter the description of the entry.
OK Click OK to save your changes back to the UAG.
Cancel Click Cancel to exit this screen without saving your changes.
To Next Page
Loading...
