Chapter 9 Wireless
UAG Series User’s Guide
150
Available
channels
This text box lists the channels that are available in the 2.4 GHz band. Select the
channels that you want the AP to use, and click the right arrow button to add them.
Channels
selected
This text box lists the channels that you allow the AP to use. Select any channels that
you want to prevent the AP from using it, and click the left arrow button to remove
them.
2.4 GHz Channel
Deployment
This field is available only when you set 2.4 GHz Channel Selection Method to auto.
Select Three-Channel Deployment to limit channel switching to channels 1,6, and
11, the three channels that are sufficiently attenuated to have almost no impact on one
another. In other words, this allows you to minimize channel interference by limiting
channel-hopping to these three “safe” channels.
Select Four-Channel Deployment to limit channel switching to four channels.
Depending on the country domain, if the only allowable channels are 1-11 then the UAG
uses channels 1, 4, 7, 11 in this configuration; otherwise, the UAG uses channels 1, 5,
9, 13 in this configuration. Four channel deployment expands your pool of possible
channels while keeping the channel interference to a minimum.
5 GHz Settings
Enable 5 GHz DFS
Aware
Select this if your APs are operating in an area known to have RADAR devices. This
allows the device to downgrade its frequency to below 5 GHz in the event a RADAR
signal is detected, thus preventing it from interfering with that signal.
Enabling this forces the AP to select a non-DFS channel.
5 GHz Channel
Selection Method
Select auto to have the AP search for available channels automatically in the 5 GHz
band.
Select manual and specify the channels the AP uses in the 5 GHz band.
Available
channels
This text box lists the channels that are available in the 5 GHz band. Select the
channels that you want the AP to use, and click the right arrow button to add them.
Channels
selected
This text box lists the channels that you allow the AP to use. Select any channels that
you want to prevent the AP from using it, and click the left arrow button to remove
them.
Apply Click Apply to save your changes back to the UAG.
Reset Click Reset to return the screen to its last-saved settings.
Table 62 Configuration > Wireless > DCS (continued)
LABEL DESCRIPTION
To Next Page
Loading...
