Chapter 48 File Manager
UAG Series User’s Guide
552
Configuration File Flow at Restart
• If there is not a startup-config.conf when you restart the UAG (whether through a
management interface or by physically turning the power off and back on), the UAG uses the
system-default.conf configuration file with the UAG’s default settings.
•If there is a startup-config.conf, the UAG checks it for errors and applies it. If there are no
errors, the UAG uses it and copies it to the lastgood.conf configuration file as a back up file. If
there is an error, the UAG generates a log and copies the startup-config.conf configuration file
to the startup-config-bad.conf configuration file and tries the existing lastgood.conf
configuration file. If there isn’t a lastgood.conf configuration file or it also has an error, the UAG
applies the system-default.conf configuration file.
• You can change the way the startup-config.conf file is applied. Include the setenv-startup
stop-on-error off command. The UAG ignores any errors in the startup-config.conf file and
applies all of the valid commands. The UAG still generates a log for any errors.
Figure 382 Maintenance > File Manager > Configuration File
Do not turn off the UAG while configuration file upload is in progress.
To Next Page
Loading...
