Chapter 49 Diagnostics
UAG Series User’s Guide
563
Figure 395 Maintenance > Diagnostics > Packet Capture
The following table describes the labels in this screen.
Table 267 Maintenance > Diagnostics > Packet Capture
LABEL DESCRIPTION
Interfaces Enabled interfaces (except for virtual interfaces) appear under Available
Interfaces. Select interfaces for which to capture packets and click the right arrow
button to move them to the Capture Interfaces list. Use the [Shift] and/or [Ctrl]
key to select multiple objects.
IP Version Select the version of the Internet Protocol (IP) by which traffic is routed across the
networks and Internet. Select any to capture packets for traffic sent by either IP
version.
Protocol Type Select the protocol type of traffic for which to capture packets. Select any to capture
packets for all types of traffic.
Host IP Select a host IP address object for which to capture packets. Select any to capture
packets for all hosts. Select User Defined to be able to enter an IP address.
Host Port This field is configurable when you set the Protocol Type to any, tcp, or udp.
Specify the port number of traffic to capture.
Continuously capture
and overwrite old ones
Select this to have the UAG keep capturing traffic and overwriting old packet capture
entries when the available storage space runs out.
To Next Page
Loading...
