ZyXEL Communications UAG5100 - Page 576

Chapter 50 Packet Flow Explore
UAG Series User’s Guide
576
Figure 410 Maintenance > Packet Flow Explore > Routing Status (Main Route)
The following table describes the labels in this screen.
Table 275 Maintenance > Packet Flow Explore > Routing Status
LABEL DESCRIPTION
Routing Flow This section shows you the flow of how the UAG determines where to route a packet. Click a
function box to display the related settings in the Routing Table section.
Routing Table This section shows the corresponding settings according to the function box you click in the
Routing Flow section.
The following fields are available if you click Direct Route, Static Route, or Main Route in the Routing
Flow section.
# This field is a sequential value, and it is not associated with any entry.
Destination This is the destination IP address of a route.
Gateway
This is the IP address of the next-hop gateway or the interface through which the traffic is
routed.
Interface
This is the name of an interface associated with the route.
Metric This is the route’s priority among the displayed routes.
Flags This indicates additional information for the route. The possible flags are:
• A - this route is currently activated.
• S - this is a static route.
• C - this is a direct connected route.
• G - the route is to a gateway (router) in the same network.
• ! - this is a route which forces a route lookup to fail.
• B - this is a route which discards packets.
• L - this is a recursive route.
Persist This is the remaining time of a dynamically learned route. The UAG removes the route after
this time period is counted down to zero.
The following fields are available if you click SiteToSite VPN in the Routing Flow section.
# This field is a sequential value, and it is not associated with any entry.
Source This is the IP address(es) of the local VPN network.