Chapter 5 Quick Setup Wizards
UAG Series User’s Guide
67
Assignment to Static and/or select PPTP or PPPoE, enter the Internet access information exactly
as your ISP gave it to you.
Figure 43 WAN and ISP Connection Settings: (PPTP Shown)
The following table describes the labels in this screen.
Table 12 WAN and ISP Connection Settings
LABEL DESCRIPTION
ISP Parameter This section appears if the interface uses a PPPoE or PPTP Internet connection.
Encapsulation This displays the type of Internet connection you are configuring.
Service Name Enter the PPPoE service name specified in the ISP account. This field is not available if
the ISP account uses PPTP.
Authentication
Type
Use the drop-down list box to select an authentication protocol for outgoing calls.
Options are:
CHAP/PAP - Your UAG accepts either CHAP or PAP when requested by this remote
node.
CHAP - Your UAG accepts CHAP only.
PAP - Your UAG accepts PAP only.
MSCHAP - Your UAG accepts MSCHAP only.
MSCHAP-V2 - Your UAG accepts MSCHAP-V2 only.
User Name Type the user name given to you by your ISP. You can use alphanumeric and -_
@$./
characters, and it can be up to 31 characters long.
To Next Page
Loading...
