Chapter 43 MAC Pinning
XGS2220 Series User’s Guide
279
Figure 199 SWITCHING > MAC Pinning
The following table describes the labels in this screen.
Table 134 SWITCHING > MAC Pinning
LABEL DESCRIPTION
Active Enable the switch button to turn on the MAC pinning function on the Switch.
Port This field displays the port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Active Select this check box to enable MAC pinning on this port. The port then has priority over other
ports in MAC address learning.
Clear this check box to disable MAC pinning.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
