ZyXEL Communications XGS2220 Series - 68.2 Policy Rules

Chapter 68 Policy Rule
XGS2220 Series User’s Guide
463
68.2 Policy Rules
Click SECURITY > ACL > Policy Rule in the navigation panel to display the screen as shown.
Figure 341 SECURITY > ACL > Policy Rule
The following table describes the labels in this screen.
68.2.1 Add/Edit a Policy Rule
You must first configure a classifier in the SECURITY > ACL > Classifier > Classifier Setup screen.
Click Add/Edit, or select an entry and click Add/Edit in the SECURITY > ACL > Policy Rule screen to
display this screen.
Table 263 SECURITY > ACL > Policy Rule
LABEL DESCRIPTION
Index This field displays the policy index number.
Active This field displays whether policy is activated or not.
Name This field displays the name you have assigned to this policy.
Classifier(s) This field displays the names of the classifier to which this policy applies.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Add/Edit Click Add/Edit to add a new entry or edit a selected one.
Delete Click Delete to remove the selected entries.