Chapter 56 VLAN
XGS2220 Series User’s Guide
375
56.6 Configure GVRP
Use this screen to configure GVRP settings on a port. Click SWITCHING > VLAN > VLAN Setup > GVRP to
display the screen as shown.
Figure 273 SWITCHING > VLAN > VLAN Setup > GVRP
The following table describes the labels in this screen.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 201 SWITCHING > VLAN > VLAN Setup > VLAN Port Setup (continued)
LABEL DESCRIPTION
Table 202 SWITCHING > VLAN > VLAN Setup > GVRP
LABEL DESCRIPTION
GVRP GVRP (GARP VLAN Registration Protocol) is a registration protocol that defines a way for
switches to register necessary VLAN members on ports across the network.
Enable the switch button to permit VLAN groups beyond the local Switch.
Port This field displays the port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
GVRP Select this check box to allow GVRP on this port.
To Next Page
Loading...
