ZyXEL Communications XGS2220 Series - Add;Edit Selective Q-In-Q

Chapter 59 VLAN Stacking
XGS2220 Series User’s Guide
403
59.6.1 Add/Edit Selective Q-in-Q
Click Add/Edit, or select an entry and click Add/Edit in the SWITCHING > VLAN Stacking > Selective QinQ
screen to display this screen.
Figure 300 SWITCHING > VLAN Stacking > Selective QinQ > Add/Edit
The following table describes the labels in this screen.
SPVID This is the service provider’s VLAN ID that adds to the packets from the subscribers.
Priority This is the service provider’s priority level in the packets.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the table
heading row to select all entries.
Add/Edit Click Add/Edit to add a new entry or edit a selected one.
Delete Click Delete to remove the selected entries.
Table 224 SWITCHING > VLAN Stacking > Selective QinQ (continued)
LABEL DESCRIPTION
Table 225 SWITCHING > VLAN Stacking > Selective QinQ > Add/Edit
LABEL DESCRIPTION
Active Enable the switch button to activate this rule.
Name Enter a descriptive name (up to 32 printable ASCII characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ]) for
identification purposes.
Port The port number identifies the port you are configuring.
CVID Enter a customer VLAN ID (the inner VLAN tag) from 1 to 4094. This is the VLAN tag carried in the
packets from the subscribers.
SPVID SPVID is the service provider’s VLAN ID (the outer VLAN tag). Enter the service provider ID (from 1 to
4094) for frames received on this port.
Priority Select a priority level (from 0 to 7). This is the service provider’s priority level that adds to the frames
received on this port.
"0" is the lowest priority level and "7" is the highest.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.