ZyXEL Communications XGS2220 Series - 45.1.3 What You Can Do - MVR

Chapter 45 Multicast
XGS2220 Series User’s Guide
303
The following table describes the fields in the above screen.
45.12 General MVR Configuration
Use this screen to view and create multicast VLANs.
Click SWITCHING > Multicast > MVR to display the screen as shown next.
Note: You can create up to five multicast VLANs and up to 256 multicast rules on the Switch.
Note: Your Switch automatically creates a static VLAN (with the same VID) when you create
a multicast VLAN in this screen.
Figure 219 SWITCHING > Multicast > MVR
The following table describes the related labels in this screen.
Table 151 SWITCHING > Multicast > IPv6 Multicast > Filtering Profile > Add Rule
LABEL DESCRIPTION
Profile Name Select a profile from the drop-down list to add a additional rule for the existing profile.
Start Address Type the starting multicast IPv6 address for a range of multicast IPv6 addresses that you want
to belong to the MLD filtering profile.
End Address Type the ending multicast IPv6 address for a range of IPv6 addresses that you want to
belong to the MLD filtering profile.
If you want to add a single multicast IPv6 address, enter it in both the Start Address and End
Address fields.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.
Table 152 SWITCHING > Multicast > MVR
LABEL DESCRIPTION
VLAN This field displays the multicast VLAN ID.
Active This field displays whether the multicast group is enabled or not.
Name This field displays the descriptive name for this setting.
Mode This field displays the MVR mode.
Source Port This field displays the source port numbers.
Receiver Port This field displays the receiver port numbers.
802.1p Priority This field displays the priority level.