ZyXEL Communications XGS2220 Series - 56.10 Configuring Protocol Based VLAN

Chapter 56 VLAN
XGS2220 Series User’s Guide
379
upstream ARP traffic from port 1, 2 and 3 will be grouped together, and all upstream Apple Talk traffic
from port 6 and 7 will be in another group and have higher priority than ARP traffic, when they go
through the uplink port to a backbone switch C.
Figure 277 Protocol Based VLAN Application Example
56.10 Configuring Protocol Based VLAN
Click the SWITCHING > VLAN > Protocol Based VLAN Setup link in the navigation panel to display the
configuration screen as shown.
Figure 278 SWITCHING > VLAN > Protocol Based VLAN Setup
The following table describes the labels in this screen.
Table 205 SWITCHING > VLAN > Protocol Based VLAN Setup
LABEL DESCRIPTION
Index This is the index number identifying this protocol based VLAN. Click any of these numbers to
edit an existing protocol based VLAN.
Active This field shows whether the protocol based VLAN is active or not.
Port This field shows which port belongs to this protocol based VLAN.
Name This field shows the name of the protocol based VLAN.
Ethernet-type This field shows which Ethernet protocol is part of this protocol based VLAN.
VID This field shows the VLAN ID of the port.
Priority This field shows the priority which is assigned to frames belonging to this protocol based
VLAN.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Add/Edit Click Add/Edit to add a new entry or edit a selected one.
Delete Click Delete to remove the selected entry.