Chapter 72 Error-Disable
XGS2220 Series User’s Guide
480
72.2 Error-Disable Status
Use this screen to view whether the Switch detected that control packets exceeded the rate limit
configured for a port or a port is disabled according to the feature requirements and what action you
configure, and related information. Click SECURITY > Errdisable > Errdisable Status to display the screen
as shown.
Figure 352 SECURITY > Errdisable > Errdisable Status
The following table describes the labels in this screen.
Table 273 SECURITY > Errdisable > Errdisable Status
LABEL DESCRIPTION
Inactive-reason mode reset
Port Enter the number of the ports (separated by a comma) on which you want to reset inactive-
reason status.
To Next Page
Loading...
