Chapter 56 VLAN
XGS2220 Series User’s Guide
382
Figure 281 SWITCHING > VLAN > Voice VLAN Setup
The following table describes the fields in the above screen.
56.11.1 Add/Edit a Voice VLAN
Click Add/Edit, or select an entry and click Add/Edit in the SWITCHING > VLAN > Voice VLAN Setup
screen to display the configuration screen.
Table 207 SWITCHING > VLAN > Voice VLAN Setup
LABEL DESCRIPTION
Voice VLAN Global Setup
Voice VLAN Click the second radio button if you want to enable the Voice VLAN feature. Type a
VLAN ID number in the box next to the radio button that is associated with the Voice
VLAN. You also need to create a static VLAN with the same VID in the SWITCHING > VLAN
> VLAN Setup > Static VLAN screen, and then connect the IP phone with the specified
OUI MAC address to a port that joins the static VLAN.
Click Disable radio button if you do not want to enable the Voice VLAN feature.
Priority Select the priority level of the voice traffic from 0 to 7. Default setting is 5. The higher the
numeric value you assign, the higher the priority for this voice traffic.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this section afresh.
Voice VLAN OUI Setup
Index This field displays the index number of the Voice VLAN.
OUI Address This field displays the OUI address of the Voice VLAN.
OUI Mask This field displays the OUI mask address of the Voice VLAN.
Description This field displays the description of the Voice VLAN with OUI address.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Add/Edit Click Add/Edit to add a new entry or edit a selected one.
Delete Click Delete to remove the selected entry.
To Next Page
Loading...
