Chapter 69 Anti-Arpscan
XGS2220 Series User’s Guide
470
Figure 345 SECURITY > Anti-Arpscan > Anti-Arpscan Host Status
The following table describes the fields in the above screen.
69.4 Anti-Arpscan Setup
Use this screen to enable Anti-Arpscan, set port and host thresholds as well as configure ports to be
trusted or untrusted. To open this screen, click SECURITY > Anti-Arpscan > Anti-Arpscan Setup.
Table 266 SECURITY > Anti-Arpscan > Anti-Arpscan Host Status
LABEL DESCRIPTION
Clear Filtered host
A filtered host is a blocked IP address.
Port List Enter a port number or a series of port numbers separated by commas and spaces, and
then click Clear to unblock all hosts connected to these ports.
Filtered host
This table lists information on blocked hosts.
Index This displays the index number of an IP address (a host) that has been blocked.
Host IP This displays the IP address of the blocked host.
MAC Address This displays the MAC address of the blocked host.
VLAN This displays the VLAN ID that shows which VLAN the blocked host is in.
Port This displays the port number to which the blocked host is connected.
State This shows Err-Disable if the ARP-request rate from this host is over the threshold. Forwarding
hosts are not displayed.
To Next Page
Loading...
