Chapter 79 Networked AV Mode
XGS2220 Series User’s Guide
611
79.42 What You Can Do
• Use the Restore Configuration screen (Section 79.43 on page 611) to upload a stored device
configuration file.
• Use the Backup Configuration screen (Section 79.44 on page 611) to save your configuration for later
use.
• Use the Save Configuration screen (Section 79.45 on page 612) to save the current configuration
settings to a specific configuration file on the Switch.
• Use the Firmware Upgrade screen (Section 79.46 on page 613) to upload the latest firmware.
• Use the Reboot System screen (Section 79.47 on page 613) to restart the Switch without physically
turning the power off and load a specific configuration file.
• Use the Tech-Support screen (Section 79.48 on page 614) to create reports for customer support if
there are problems with the Switch.
79.43 Restore Configuration
Use this screen to restore a previously saved configuration file from your computer to the Switch.
Click MAINTENANCE > Configuration > Restore Configuration to access this screen.
Figure 456 MAINTENANCE > Configuration > Restore Configuration
1 Click Choose File or Browse to locate the configuration file you wish to restore.
2 After you have specified the file, click Restore.
The Switch will run on the restored configuration after the restore process.
Figure 457 Configuration Restoring
79.44 Backup Configuration
Backing up your Switch configurations allows you to create various “snap shots” of your device from
which you may restore at a later date. Use this screen to back up your current Switch configuration to a
computer.
To Next Page
Loading...
