ZyXEL Communications XGS2220 Series - 62.5 DHCPv4 VLAN Setting

Chapter 62 DHCP
XGS2220 Series User’s Guide
418
62.5 DHCPv4 VLAN Setting
Use this screen to configure your DHCP settings based on the VLAN domain of the DHCP clients. Click
NETWORKING > DHCP > DHCPv4 Relay > DHCP Relay VLAN Setting to display the screen as shown.
Figure 311 NETWORKING > DHCP > DHCPv4 Relay > DHCP Relay VLAN Setting
The following table describes the labels in this screen.
Table 234 NETWORKING > DHCP > DHCPv4 Relay > DHCP Relay VLAN Setting
LABEL DESCRIPTION
DHCP Relay VLAN Setting
VID This field displays the ID number of the VLAN group to which this DHCP settings apply.
Remote
DHCP Server
This displays the IP address of a DHCP server in dotted decimal notation.
Source
Address
This field displays the source IP address you configured for DHCP requests from clients on this
VLAN.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Add/Edit Click Add/Edit to add a new entry or edit a selected one.
Delete Click Delete to remove the selected entries.
Port
Use this section to apply a different DHCP option 82 profile to certain ports in a VLAN.
Index This field displays a sequential number for each entry. Click an index number to change the
settings.
VID This field displays the VLAN to which the ports belongs.
Port This field displays the ports to which the Switch applies the settings.
Profile Name This field displays the DHCP option 82 profile that the Switch applies to the ports in this VLAN.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Add/Edit Click Add/Edit to add a new entry or edit a selected one.
Delete Click Delete to remove the selected entries.