ZyXEL Communications XGS2220 Series - Add MLD Snooping-Proxy Filtering Profile; MLD Snooping-Proxy Filtering Profile

Chapter 45 Multicast
XGS2220 Series User’s Guide
301
45.11 MLD Snooping-proxy Filtering Profile
Use this screen to view and create MLD filtering profiles.
Click SWITCHING > Multicast > IPv6 Multicast > Filtering Profile to display the screen as shown.
Figure 216 SWITCHING > Multicast > IPv6 Multicast > Filtering Profile
The following table describes the fields in the above screen.
45.11.1 Add MLD Snooping-proxy Filtering Profile
Use this screen to create an MLD filtering profile and set the range of the multicast addresses.
Click Add Profile in the SWITCHING > Multicast > IPv6 Multicast > Filtering Profile to display the screen as
shown.
Table 149 SWITCHING > Multicast > IPv6 Multicast > Filtering Profile
LABEL DESCRIPTION
MLD Snooping-proxy Filtering Profile
Profile Name This field displays the descriptive name of the profile.
Start Address This field displays the start of the multicast IPv6 address range.
End Address This field displays the end of the multicast IPv6 address range.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Add Profile Click this to add a new MLD Snooping-proxy filtering profile.
Add Rule Click Add Rule to add a new rule and specify the profile it belongs to in the Add Rule screen.
You can also select a profile entry and click Add Rule to add an additional rule for the
selected profile.
Delete Select a profile and click Delete to remove the selected profile and the accompanying
rules.
Select a rule from a profile and click Delete to remove the selected rule.