Chapter 45 Multicast
XGS2220 Series User’s Guide
304
45.12.1 Add/Edit MVR
Use this screen to create or edit multicast VLANs and select the receiver ports and a source port for
each multicast VLAN.
To access this screen, click Add/Edit or select an existing entry and click Add/Edit in the SWITCHING >
Multicast > MVR screen.
Figure 220 SWITCHING > Multicast > MVR > Add/Edit
The following table describes the related labels in this screen.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Add/Edit Click Add/Edit to add a new multicast VLAN or edit a selected one.
Delete Select the entries that you want to remove, then click Delete to delete multicast VLANs.
Table 152 SWITCHING > Multicast > MVR (continued)
LABEL DESCRIPTION
Table 153 SWITCHING > Multicast > MVR > Add/Edit
LABEL DESCRIPTION
Active Enable the switch button to enable MVR to allow one single multicast VLAN to be shared
among different subscriber VLANs on the network.
Group Name Enter a descriptive name (up to 32 printable ASCII characters except [ ? ], [ | ], [ ' ], [ " ], or [ ,
]) for identification purposes.
Multicast VLAN ID Enter the VLAN ID (1 to 4094) of the multicast VLAN.
To Next Page
Loading...
