Chapter 3 Hardware Panels
XGS2220 Series User’s Guide
51
authority or an electrician.
This device must be grounded. Do this before you make other
connections.
3.2.2 AC Power Connection
Note: Make sure you are using the correct power source as shown on the panel and that no
objects obstruct the airflow of the fans (located on the side of the unit).
To connect power to the Switch, insert the female end of the power cord to the AC power receptacle
on the rear panel. Connect the other end of the supplied power cord to a power outlet.
Power Cord Requirement (XGS2220-54HP / XGS2220-54FP)
Make sure to use the provided or designated power cord for your
Switch.
The following table describes the power cord requirements for XGS2220-54HP / XGS2220-54FP.
Note: If you need to replace the power cord, contact your local vendor.
Installing the Retainer Clip
Install the retainer clip to prevent accidental removal of the power cord.
1 Loosely wrap the clip on the retainer to the power cord.
2 Push the pronged-end of the retainer clip into the Retainer Holder hole until it locks into place.
Table 7 XGS2220-54HP / XGS2220-54FP Power Cord Specifications
COUNTRIES SPECIFICATION SUPPLY VOLTAGE
Europe and United Kingdom 18 AWG 230 V
North America 14 AWG 110 V
To Next Page
Loading...
