Chapter 68 Policy Rule
XGS2220 Series User’s Guide
466
68.3 Policy Example
The figure below shows an example SECURITY > ACL > Policy Rule screen where you configure a policy
to limit bandwidth and discard out-of-profile traffic on a traffic flow classified using the Example classifier
(refer to Section 67.5 on page 460).
Diffserv Select No change to keep the TOS and/or DSCP fields in the packets.
Select Set the packet’s TOS field to set the TOS field with the value you configure in the TOS
field.
Select Set the Diffserv Codepoint field in the frame to set the DSCP field with the value you
configure in the DSCP field.
Outgoing Select Send the packet to the mirror port to send the packet to the mirror port.
Select Send the packet to the egress port to send the packet to the egress port.
Select Set the packet's VLAN ID to set the packet’s VLAN ID.
Metering Enable the switch button to activate bandwidth limitation on the traffic flows then set the
actions to be taken on out-of-profile packets.
Out of profile
action
Select the actions to be performed for out-of-profile traffic.
Select Drop the packet to discard the out-of-profile traffic.
Select Change the DSCP value to replace the DSCP field with the value specified in the Out of
profile DSCP field.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.
Table 264 SECURITY > ACL > Policy Rule > Add/Edit (continued)
LABEL DESCRIPTION
To Next Page
Loading...
