Chapter 57 VLAN Isolation
XGS2220 Series User’s Guide
391
Figure 290 SWITCHING > VLAN Isolation
The following table describes the labels in this screen.
57.2.1 Add/Edit a VLAN Isolation Rule
Click Add/Edit, or select an entry and click Add/Edit in the SWITCHING > VLAN Isolation screen to display
this screen.
Figure 291 SWITCHING > VLAN Isolation > Add/Edit
The following table describes the labels in this screen.
Table 214 SWITCHING > VLAN Isolation
LABEL DESCRIPTION
Index This is the index number of the rule.
Active This shows whether this rule is activated or not.
Name This is the descriptive name for this rule.
VLAN ID This is the VLAN to which this rule is applied.
Promiscuous Ports This shows the ports that can communicate with any ports in the same VLAN.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Add/Edit Click Add/Edit to add a new entry or edit a selected one.
Delete Click Delete to remove the selected entries.
Table 215 SWITCHING > VLAN Isolation > Add/Edit
LABEL DESCRIPTION
Active Enable the switch button to enable VLAN Isolation in a VLAN.
Name Enter a descriptive name (up to 32 printable ASCII characters except [ ? ], [ | ], [ ' ], [ " ] or [ ,
]) for identification purposes.
VLAN ID Enter a VLAN ID from 1 to 4094. This is the VLAN to which this rule applies.
Promiscuous Ports Enter the number of the ports that can communicate with any ports in the same VLAN.
Other ports belonging to this VLAN will be added to the isolation list and can only send and
receive traffic from the ports you specify here.
To Next Page
Loading...
