ZyXEL Communications XGS2220 Series - Add;Edit an Ipv6 Source Guard Policy

Chapter 75 ARP Inspection
XGS2220 Series User’s Guide
510
Figure 375 SECURITY > IPv6 Source Guard > IPv6 Source Guard > IPv6 Source Guard Policy
The following table describes the labels in this screen.
75.10.1 Add/Edit an IPv6 Source Guard Policy
Click Add/Edit, or select an entry and click Add/Edit in the SECURITY > IPv6 Source Guard > IPv6 Source
Guard > IPv6 Source Guard Policy screen to display this screen.
Figure 376 SECURITY > IPv6 Source Guard > IPv6 Source Guard > IPv6 Source Guard Policy > Add/Edit
The following table describes the labels in this screen.
Table 295 SECURITY > IPv6 Source Guard > IPv6 Source Guard > IPv6 Source Guard Policy
LABEL DESCRIPTION
Index This field displays a sequential number for each policy.
Name This field displays the descriptive name for identification purposes for this IPv6 source guard
policy.
Validate Address This field displays the Validate Address status for this IPv6 source guard policy.
Validate Prefix This field displays the Validate Prefix status for this IPv6 source guard policy.
Link Local This field displays the Link Local traffic status for this IPv6 source guard policy.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Add/Edit Click Add/Edit to add a new entry or edit a selected one.
Delete Click Delete to remove the selected entries.
Table 296 SECURITY > IPv6 Source Guard > IPv6 Source Guard > IPv6 Source Guard Policy > Add/Edit
LABEL DESCRIPTION
Name Enter a descriptive name for identification purposes for this IPv6 source guard policy. You can
enter up to 32 printable ASCII characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ].
Validate Address Select Validate Address to have IPv6 source guard forward valid addresses that are stored in
the binding table.
Validate Prefix Select Validate Prefix to have IPv6 source guard forward valid prefixes that are stored in the
binding table.