Chapter 75 ARP Inspection
XGS2220 Series User’s Guide
511
75.11 IPv6 Source Guard Port Setup
Use this screen to apply configured IPv6 source guard policies to ports you specify. Use port * to apply a
policy to all ports. To open this screen, click SECURITY > IPv6 Source Guard > IPv6 Source Guard > IPv6
Source Guard Port Setup.
Figure 377 SECURITY > IPv6 Source Guard > IPv6 Source Guard > IPv6 Source Guard Port Setup
The following table describes the labels in this screen.
Link Local Select Permit to allow data traffic from all link-local addresses; otherwise leave the setting at
Deny. A link-local address is an IPv6 unicast address that can be automatically configured on
any interface using the link-local prefix FE80::/10 and the interface identifier in the modified
EUI-64 format.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.
Table 296 SECURITY > IPv6 Source Guard > IPv6 Source Guard > IPv6 Source Guard Policy > Add/Edit
LABEL DESCRIPTION
Table 297 SECURITY > IPv6 Source Guard > IPv6 Source Guard > IPv6 Source Guard Port Setup
LABEL DESCRIPTION
Port This field displays the port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Policy Name Select an IPv6 source guard policy that the Switch will apply to this port.
To Next Page
Loading...
