ZyXEL Communications XGS2220 Series - 67.2 Classifier Status; 67.3 Classifier Setup

Chapter 67 Classifier
XGS2220 Series User’s Guide
454
67.2 Classifier Status
Use this screen to view the classifiers configured on the Switch and how many times the traffic matches
the rules.
Click SECURITY > ACL > Classifier > Classifier Status to display the configuration screen as shown.
Figure 336 SECURITY > ACL > Classifier > Classifier Status
The following table describes the labels in this screen.
67.3 Classifier Setup
Use this screen to view and configure the classifiers. After you define the classifier, you can specify
actions (or policy) to act upon the traffic that matches the rules.
Click SECURITY > ACL > Classifier Setup to display the configuration screen as shown.
Table 257 SECURITY > ACL > Classifier > Classifier Status
LABEL DESCRIPTION
Index This field displays the index number of the rule.
Active This field displays whether the rule is activated or not.
Weight This field displays the rule’s weight. This is to indicate a rule’s priority when the match order is set
to manual in the SECURITY > ACL > Classifier > Classifier Global Setting screen.
The higher the number, the higher the rule’s priority.
Name This field displays the descriptive name for this rule. This is for identification purpose only.
Match Count This field displays the number of times a rule is applied. It displays '–' if the rule does not have
count enabled.
Rule This field displays a summary of the classifier rule’s settings.
Clear the Classifier
Any Select Any, then click Clear to clear the matched count for all classifiers.
Classifier Select Classifier, enter a classifier rule name and then click Clear to erase the recorded
statistical information for that classifier, or select Any to clear statistics for all classifiers.
Clear Click Clear to erase the recorded statistical information for the classifier.