Chapter 3 Hardware Panels
XGS2220 Series User’s Guide
48
Note: Do NOT pull the transceiver out by force. You could damage it. If the transceiver will not
slide out, grasp the tabs on both sides of the transceiver with a slight up or down motion
and carefully slide it out of the slot. If unsuccessful, contact Zyxel Support to prevent
damage to your Switch and transceiver.
5 Insert the dust plug into the ports on the transceiver and the cables.
Figure 21 Removing the Fiber Optic Cables
Figure 22 Opening the Transceiver’s Latch Example
Figure 23 Transceiver Removal Example
3.1.3 Console Port
This USB Type C connector is for troubleshooting only.
3.2 Rear Panel
The following figures show the rear panels of the Switch. The rear panels contain:
Figure 24 Rear Panel: XGS2220-30
Figure 25 Rear Panel: XGS2220-30HP
To Next Page
Loading...
