Chapter 45 Multicast
XGS2220 Series User’s Guide
302
Figure 217 SWITCHING > Multicast > IPv6 Multicast > Filtering Profile > Add Profile
The following table describes the fields in the above screen.
45.11.2 Add MLD Snooping-proxy Filtering Rule
Use this screen to create a multicast addresses range rule of the MLD filtering profile.
Click Add Rule in the SWITCHING > Multicast > IPv6 Multicast > Filtering Profile to display this screen.
Figure 218 SWITCHING > Multicast > IPv6 Multicast > Filtering Profile > Add Rule
Table 150 SWITCHING > Multicast > IPv6 Multicast > Filtering Profile > Add Profile
LABEL DESCRIPTION
Profile Name Enter a descriptive name (up to 32 printable ASCII characters except [?], [|], [‘], [“], [,]) for
the profile for identification purposes.
To configure additional rules for a profile that you have already added, enter the profile
name and specify a different IP multicast address range.
Start Address Type the starting multicast IPv6 address for a range of multicast IPv6 addresses that you want
to belong to the MLD filtering profile.
End Address Type the ending multicast IPv6 address for a range of IPv6 addresses that you want to
belong to the MLD filtering profile.
If you want to add a single multicast IPv6 address, enter it in both the Start Address and End
Address fields.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.
To Next Page
Loading...
