Chapter 46 Static Multicast Forwarding
XGS2220 Series User’s Guide
314
VID You can forward frames with matching destination multicast IPv4 address to ports within a VLAN
group. Enter the ID that identifies the VLAN group here. If you do NOT have a specific target
VLAN, enter 1.
Port Enter the ports where frames with destination multicast IPv4 address that matched the entry
above are forwarded. You can enter multiple ports separated by (no space) comma (,) or
hyphen (-). For example, enter “3-5” for ports 3, 4, and 5. Enter “3,5,7” for ports 3, 5, and 7.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.
Table 159 SWITCHING > Static Multicast Forwarding By IP > Add/Edit (continued)
LABEL DESCRIPTION
To Next Page
Loading...
