Chapter 4 Web Configurator
XGS2220 Series User’s Guide
90
PoE Setup For PoE models.
This link takes you to a screen where you can set priorities, PoE power-up settings and schedule so
that the Switch is able to reserve and allocate power to certain PDs.
Port Setup This link takes you to a screen where you can configure settings for individual Switch ports.
ZULD This link takes you to screens where you can enable ZULD on a port and configure related set-
tings.
SWITCHING
Layer 2 Proto-
col Tunneling
This link takes you to a screen where you can configure L2PT (Layer 2 Protocol Tunneling) settings
on the Switch.
Loop Guard This link takes you to a screen where you can configure protection against network loops that
occur on the edge of your network.
MAC Pinning This link takes you to a screen where you can set specific ports to have priority over other ports in
MAC address learning.
Mirroring Click the link to unfold the following sub-link menu.
Mirroring This link take you to a screen where you can copy traffic from one port or ports to another port in
order to examine the traffic from the first port without interference.
Multicast Click the link to unfold the following sub-link menu.
IPv4
Multicast
This link takes you to screen where you can configure various IPv4 multicast features, IGMP snoop-
ing, filtering and create multicast VLANs.
IPv6
Multicast
This link takes you to screen where you can configure various IPv6 multicast features, MLD snoop-
ing-proxy, filtering and create multicast VLANs.
MVR This link takes you to screens where you can create multicast VLANs and select the receiver ports
and a source port for each multicast VLAN.
Static
Multicast
Forwarding
By MAC
This link takes you to a screen where you can configure static multicast MAC addresses for port(s).
These static multicast MAC addresses do not age out.
Static
Multicast
Forwarding
By IP
This link takes you to a screen where you can configure static multicast IP addresses for port(s).
These static multicast IP addresses do not age out.
PPPoE Interme-
diate Agent
This link takes you to screens where you can enable PPPoE (Point-to-Point Protocol over Ethernet)
Intermediate Agent and configure per-port, per-port-per-VLAN settings.
QoS Click the link to unfold the following sub-link menu.
Diffserv This link takes you to screens where you can enable DiffServ, configure marking rules and set
DSCP-to-IEEE802.1p mappings.
Queuing
Method
This link takes you to a screen where you can set priorities for the queues of the Switch. This distrib-
utes bandwidth across the different traffic queues.
Priority
Queue
This link takes you to a screen where you can set priority tags for different traffic types and specify
the priority levels.
Bandwidth
Control
This link takes you to a screen where you can cap the maximum bandwidth allowed on a port.
sFlow This link takes you to screens where you can configure sFlow settings on the Switch.
Spanning Tree
Protocol
Click the link to unfold the following sub-link menu.
Spanning
Tree
Protocol
Status
This link takes you to a screen where you can view the STP status in the different STP modes (RSTP,
MRSTP or MSTP) you can configure on the Switch.
Table 29 Navigation Panel Links (Standard Mode) (continued)
LINK DESCRIPTION
To Next Page
Loading...
