Appendix A Log Descriptions
ZyWALL USG 100/200 Series User’s Guide
976
Table 295 Connectivity Check Logs
LOG MESSAGE DESCRIPTION
Can't open link_up2 Cannot recover routing status which is link-down.
Can not open %s.pid Cannot open connectivity check process ID file.
%s: interface name
Can not open %s.arg Cannot open configuration file for connectivity check process.
%s: interface name
The connectivity-
check is activate for
%s interface
The link status of interface is still activate after check of
connectivity check process.
%s: interface name
The connectivity-
check is fail for %s
interface
The link status of interface is fail after check of connectivity
check process.
%s: interface name
Can't get gateway IP
of %s interface
The connectivity check process can't get the gateway IP
address for the specified interface.
%s: interface name
Can't alloc memory The connectivity check process can't get memory from OS.
Can't load %s module The connectivity check process can't load module for check
link-status.
%s: the connectivity module, currently only ICMP available.
Can't handle 'isalive'
function of %s module
The connectivity check process can't execute 'isalive' function
from module for check link-status.
%s: the connectivity module, currently only ICMP available.
Create socket error The connectivity check process can't get socket to send
packet.
Can't get IP address
of %s interface
The connectivity check process can't get IP address of
interface.
%s: interface name.
Can't get flags of %s
interface
The connectivity check process can't get interface
configuration.
%s: interface name
Can't get remote
address of %s
interface
The connectivity check process can't get remote address of
PPP interface
%s: interface name
Can't get NETMASK
address of %s
interface
The connectivity check process can't get netmask address of
interface.
%s: interface name
Can't get BROADCAST
address of %s
interface
The connectivity check process can't get broadcast address of
interface
%s: interface name
To Next Page
Loading...
