Pannoramic 250 1.15 User’s Guide
Warning!
Use only electric fuses which are rated for the specified nominal current. You
are prohibited from using makeshift fuses or short-circuiting of a fuse holder.
Warning!
The Pannoramic 250 does not include any special facilities to protect from
samples with an etching, potentially infectious, toxic, radioactive or other
health-damaging effect. You are under obligation to comply with all currently
binding legislation, notably, national accident prevention rules when handling
samples of this kind.
Caution!
Dirt or dust may adversely impact the operating capability of the Pannoramic
250. For this reason, measures must be taken to eliminate such influences to a
maximum possible degree. During periods of non-use, the Pannoramic 250
must be protected with a dust cover. Check that power is turned off before you
put the cover on.
Crush hazard!
There is crush hazard in the movement area of the slide insert during operation.
Please note that the digitizing process has to be interrupted and the insert
moved via software to the output position before removing the insert.
Warning!
Clogged or covered ventilation slots may result in a heat build-up with a
damaging effect for the Pannoramic 250. In extreme cases, this may also cause
fire. Keep the ventilation slots always unobstructed and refrain from inserting or
dropping objects into a ventilation slot.
Warning!
A defective Pannoramic 250 is not classified as domestic waste. It must be
properly disposed in accordance with currently valid legal requirements.
Warning!
The Pannoramic 250 may not be operated by other than properly instructed
persons. Operating personnel must be fully aware of the potential dangers
which a particular field of application involves. The Pannoramic 250 is a
precision instrument which may suffer a significant reduction in operational
functions or even physical destruction following intervention performed in any
nonconforming manner.
Warning!
If an X-Cite 120 illuminator is used, the corresponding warnings included in the
manufacturer’s operating manual have to be observed.
March 13, 2012 – Rev. 1 3DHISTECH Ltd. 9(135)
To Next Page
Loading...
