3DHISTECH Pannoramic 250 - External Application Call Settings

Pannoramic 250 1.15 User’s Guide 4 Software Description
4.2.4 External Application Call Settings
Figure 27 – External Application Settings
These settings open any external application (.exe or .bat) as defined. For example, it might start the
Viewer software after finishing scanning, or stop the computer after scanning is finished.
You can define external application call settings for the following cases:
• Scan Finished Call
• Error Occurred Call
You can define the external software by entering the file path in the Application box, or by browsing
for it by clicking .
If you define parameters in the Parameters box, it will pass them to the software that it starts. If no
parameter is defined, then the parameter will not be passed. The default parameters are the
following:
• For Scan Finished Call: "<SLIDENAME>" – transfers the slide name
• For Error Occurred Call: "<ERRORTEXT>" – transfers the error message
March 13, 2012 – Rev. 1 3DHISTECH Ltd.
49(135)