3M XT-1 - Configuring with a Computer

3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 7 of 65
Configuration
Service (Shift) button Use the Service button to access upper-
case letters or to initiate a service call to
3M or as a confirmation in some items.
Pressing and holding the Service button while
editing a field that permits alphabet letter entry
(e.g., store address) shifts the letter to upper case.
In run mode, press and hold the Service button,
then enter your passcode to initiate an internet
request for help from 3M. A 3M representative
will call your store telephone number shortly after
you initiate the request. Your base station must be
connected to the internet for this function to work.
If you press the Service button and do not enter
a passcode, the base station will go to a Service
screen used for installation and troubleshooting
The directional arrows can be used for scrolling from one menu item to another
or to scroll through available choices when editing fields.
Configuring with a Computer
All of the procedures in this chapter assume that you are using the display to configure your base station(s).
However, the base station can function as a web server, which means it can be configured using a PC. The
web- serve functionality is disabled on a new base station, so it must be enabled and configured on site.
To set up web-server functionality:
 • Connectthebasestation:
 • Peer-to-Peer - a direct connection between the base station and the PC using a crossover cable
  • Privatenetwork- a connection between the base station and a router, switch or
hub using an Ethernet cable. The PC is somewhere on the same network.
 • Enterthecongurationmode,seepage5.
 • Select 16 Network Setup .
 • Changethevaluesfor IP address, subnet mask, default gateway, E-mail
server, and Your E-Mail Address Suix according to the table below.
 • Cyclethepowertothebasestation.
 • Enterthecongurationmode.
 • Select
16 Network Setup .
 • Changethevaluesfor
web server enabled and email enabled to Yes .
 • Cyclethepowertothebasestation.