3M XT-1 - Create and Load Templates; Reboot System; Check the Revision Levels; Activate the Backup Intercom

3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 24 of 65
Configuration
Create and Load Templates
You can save an entire base station configuration as a file on a PC and use the file as a
template for other base stations. You must be using a PC to use templates.
Reboot System
Perform the following procedure to cleanly power down, then power up without unplugging the system:
 • Enterthecongurationmode,seepage5.
 • Select 16 Reboot System.
 • Changethevalueof Power Cycle Complete System to Yes .
 • PressService.
Check the Revision Levels
Perform the following procedure to view the revision levels and serial numbers of your base station:
 • Enterthecongurationmode,seepage5.
 • Select 18 Revision Levels .
Activate the Backup Intercom
Many systems include a wired backup intercom system that can be used if the main wireless system
cannot be used. If your system has a backup intercom system, perform the following steps to activate it:
 • Removethebasestationcover.
 • Pressandlatchthetwoswitchesnamed“BACKUPINTERCOM.”