3M XT-1 - Store Is Now Closed Prompt; Pull Ahead Prompt

3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 16 of 65
Configuration
On the second base station:
 • Enterthebasestationcongurationmode,seepage5.
 • Changethevaluefor
07 Global Settings > Number of
Base Stations at This Site to 2 .
 • PressEnter to implement the change.
 • Onthesecondbasestation,stations,changethevaluefor 07 Global
Settings > Lane Number of This Base Station to 2 .
Store is Now Closed Prompt
Perform the following procedure to enable or disable the automatic store closed
prompt to let customers know in your absence that the store is closed:
Note:
Make sure that you disable the automatic store closed prompt in stores that are open 24 hours.
I. Enter the base station configuration mode, see page 5.
 • Changethevaluefor 07 Global Settings > “Store
is Now Closed” Prompt? to Yes or No .
Pull Ahead Prompt
You can let customers know to pull ahead when they are at order point
#2 in a tandem drive thru when it is out-of-service.
Figure 1
Pick Up
Cash
Orde
r
Point #2
Orde
r
Point #1
Figure1
Perform the following procedure on Base #2 to enable or disable the automatic pull ahead for Order Point #2:
 • Enterthebasestationuserservicemode,seepage5.
 • Changethevaluefor 07 Global Settings > “Pull Ahead”
Prompt (Tandem Only)? to Yes or No .