3M XT-1 - Operating the Wireless Communication System

3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 19 of 65
Configuration
In the event the Kitchen Noise Reduction feature has been disabled due to a headset with an
olderversionofsoftwarehavingsignedon,usethebasestation’smenutoidentifyandremove
the offending headset(s) before restarting the base station, in order to restore the feature.
1. Identify the serial number(s) of the headset or headsets that have a software version other than v5.11
  • Enterthebasestationcongurationmode,seepage5.
  • Navigateto
08 Headset Setup > Currently Editing Headset .
   • Press 3 or 4 if necessary to scroll through the headsets. The
software version appears below the headset ID number.
2. Unregister the headset(s) identified above by performing the following steps
  • Enterthebasestationcongurationmode,seepage5.
  • Select 04 Registration > 2 Remove Headsets .
  • Scrolltothenumberoftheheadsetyouwanttoun-register.
  • PressEnter.
3. Rebooting the base station will now restore the Kitchen Noise Reduction feature.
Order Taking Modes Setup
Perform the following procedure to enable or disable some of the seven
different order taking modes from appearing on the Run Menu:
 • Enterthebasestationcongurationmode,seepage5.
 • Navigateto 09 O.T. Modes Setup .
 • Changethevalueforeachofthefollowingoptionsto Yes or No :
 • Manual Listen/Push To Talk
 • Manual Listen/Manual Latching Talk
 • Auto Listen/Push To Talk
 • Auto Listen/Manual Latching Talk
 • Hands Free
 • Outside
 •  Always On (Bypass Vehicle Detector)
(Press 5 or 6 to scroll up and down the list)
Notes:
Order taking modes are described in the Operation section.
3M recommends you do not set up more than three order taking modes.