3M XT-1 - Set Playback through Monitor; Turn on Restaurant Closed Playback Message; Turn on Tone to Headsets During Greeter Playback

3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 47 of 65
Appendix: Greeter Module
:GREETER MESSAGE PROPERTIES: h
Playback Through The Monitor?<YES>
Tone To Headsets During Playback?<NO >
Restaurant Closed Playback Message<OFF> i
Set Playback through Monitor
You have the choice of allowing the greeting to be played through the monitoring
speaker in addition to being played to the customer at the order point.
Perform the following procedure to enable or disable playback through the monitor:
1. Navigate to Playback Through The Monitor .
2. Change the value of the playback setting. Your choices are:
• YES - The greeting will play on the grill monitor speaker as well as the order point.
•
NO - The greeting will only be heard at the order point.
Turn on Tone to Headsets During Greeter Playback
If the greeting is not playing over the headsets, a continuous tone can be played while the customer is hearing
the greeting. This permits the order taker to know when the greeting is playing and when it has stopped.
To enable or disable the tone during greeter playback:
1. Navigate to Tone To Headsets During Playback .
2. Change the value of the playback setting. Your choices are:
•
YES - A tone will play in the headsets while the greeting
message plays to the customer at the order point.
• NO - No tone will play in the headsets.
Turn on Restaurant Closed Playback Message
You can assign a standard message to be played to customers during hours when the restaurant is
closed. The clock and store hours must be set correctly, and the actual message must be recorded as
Type CLOSED, then it can be set to activate automatically whenever the restaurant is closed.
To select which restaurant closed playback message is chosen:
1. Navigate to
Restaurant Closed Playback Message .
2. Change the value of the playback setting. Your choices are:
• OFF - The factory provided “Store Closed” message is used.
•
ON - The custom recorded CLOSED message is used.